Evaluating and optimizing Raman analytical protocols for CO2 fluids
Main Article Content
Abstract
Raman spectroscopy is widely used to quantify CO2 density in geological fluids, yet acquisition parameters, spectral processing methodologies and densimeter calibrations vary between laboratories. The precision of Raman CO2 measurements, and the broader applicability of densimeters generated for a specific instrument, are still debated. This study describes a series of experiments to investigate the effect of different instrument and acquisition parameters on CO2 densities and their errors that can be performed on different Raman instruments, allowing users to determine analytical best practices. First, we discuss the effect of spectral non-linearity, demonstrating that shifts in the selected acquisition window and the choice of Ne lines used for drift correction can generate a diversity of densimeters on a single instrument. However, our repeat measurements of natural fluid inclusion (FI) standards over ~3 years yield a 1σ variation of <0.01 g cm−3, indicating that when consistent methodologies are applied to calibration data and unknowns, Raman analyses are highly reproducible over many years. We then investigate the effect of parameters such as acquisition time, laser power, and sample positioning on peak fitting errors, rebutting recent suggestions that Raman analyses are associated with large uncertainties in Fermi-diad splitting. We show that although high laser powers greatly improve signal:noise ratios (and thus reduce peak fitting errors), natural fluid inclusions hosted in olivine show changes in calculated density outside analytical error with increasing powers (density changing by ~0 to 0.09 g cm−3 per 10 mW of increased power). The amount of heating of the trapped fluid, and thus the change in density, varies drastically on a sample-by-sample basis, with larger amounts of heating in materials hosting the fluid with high absorption coefficients (melt inclusions, and low Fo olivines). We recommend that users assess the degree of laser heating experienced by their samples and select a laser power that limits density changes to a level that will not compromise the objectives of their study. We also offer practical strategies to optimize signal without raising laser power, noting that small changes in focus and x-y position can greatly increase signal intensity.
Downloads
Article Details

This work is licensed under a Creative Commons Attribution 4.0 International License.
© The Author(s).
Submission of an original manuscript to Volcanica will be taken to mean that it represents original work not previously published, and not being considered for publication elsewhere.
The Creative Commons Attribution 4.0 International License permits unrestricted use, distribution, and reproduction in any medium, provided you give appropriate credit to the original author(s) and the source, provide a link to the Creative Commons license, and indicate if changes were made.
Accepted 2026-08-07
Published 2026-08-24
